Click on any photo to enlarge. For Easy Diamond Ground instructions, please click here.
Note: Use protective eye wear and work gloves for the installation.
To view the Valley View Lawn Edging Installation Video, please click here.
Step 1.
Unravel the coiled edging out of the box and place a source of weight to keep down both ends of the edging. Only lay uncoiled edging on pavement and not on grass. If the temperature is below 65 degrees in direct sun, the edging will need to be exposed to the sun for a minimum of two days. If it is between 65-75 degrees in direct sun, 8 hours. In excess of 75 degrees in direct sun, three to four hours will be sufficient.
NOTE: This method will allow for EASIER installation as the goal is to install the edging as a flat versus a coiled piece. Installing the product right from the packaging will create misery in installing the edging and affect the ability for the edging to stay in the ground.
Step 2:
Dig a 4-5 inch trench along lawn edge
Step 3:
Sink edging into trench with the bottom "V" lip facing the rocks or mulch
Step 4:
Secure edging with stakes facing the grass as indicated
Step 5:
Sink stake through the fin every 5 feet at a 45 degree angle
Step 6:
For connecting two sections of edging together, cut five inches from one of the sections of bead.
Attach both sections with a connecting plug.
Attach both sections with a connecting plug.
Hammer the anchor stake through both sections of edging.
Made in the U.S.A.
